I can connect cura and print objects via the usb port but I would like to use Repetier to send info.
I am using windows7 on a pc connected with a usb lead direct to the printer board . All I get on the log is a list of lines
(n55, n56 etc) usually M105 and asterix with a number after it scrolling up.
Some times I get
communication timeout - reset send buffer block in red
I go to manual control and get x command waiting every time I try to jog. Eventually this goes back to idle and then back to 1 command waiting as if it is trying to communicate.
This looks like I have the baud rate wrong but I have tried all sort of baud rates without change?
Anybody know how to set up Repetier to work with the Anet A8?
thanks
I am using windows7 on a pc connected with a usb lead direct to the printer board . All I get on the log is a list of lines
(n55, n56 etc) usually M105 and asterix with a number after it scrolling up.
Some times I get
communication timeout - reset send buffer block in red
I go to manual control and get x command waiting every time I try to jog. Eventually this goes back to idle and then back to 1 command waiting as if it is trying to communicate.
This looks like I have the baud rate wrong but I have tried all sort of baud rates without change?
Anybody know how to set up Repetier to work with the Anet A8?
thanks