Hi
i used the
the problem is that the display works fine... i can control homing , read the sd card but when i press to print a file from the sd card then the dispaly shows for few seconds below that printer is printing and then goes again to the previous state... like being in stand by mode... (no errors appearing )
The file i had in the sd card has been sliced with cura engine with repetier host 1.6.2 i am using
When i am using the usb cable to send the file to the printer.. it works fine and printed
thanks in advance
i used the
Repetier-Firmware configuration tool 0.92.9 version
to update my previous setup in order to add a LCD screen support with SD cardthe problem is that the display works fine... i can control homing , read the sd card but when i press to print a file from the sd card then the dispaly shows for few seconds below that printer is printing and then goes again to the previous state... like being in stand by mode... (no errors appearing )
The file i had in the sd card has been sliced with cura engine with repetier host 1.6.2 i am using
When i am using the usb cable to send the file to the printer.. it works fine and printed
thanks in advance