Hi everyone,
I've got my replicator 2 bot and i wanted to go a deeper into different slicing techniques.
so far repetier seems to provide the best preview per slice, and best feedback from the all different slicers under the same roof.
however i haven't been able to find any info on how to get the 2 working together.
I Managed to connect them but when i hit print it just stays on printing mode 0% and nothing is happening.
Is it at all possible to send sliced models to the makerbot via reptier?
I gathered the makerbot firmware might not support this .
can upload a different firmware on the makerbot?
any help would be highly appreciated.
thanks